The schedule of work.

Old 100-amp panels and Federal Pacific boxes can't keep up with modern loads — heat pumps, EV chargers, induction ranges, and full-house renovations all want amperage your meter base never planned for. We pull a permit, coordinate the utility cut, and bring the whole service up to current code.

A car charger is a 20-year decision. We size the circuit for the future, not just the EV in your driveway today, run conduit cleanly, and wire to the charger's OEM spec — no melted plugs, no nuisance trips.

A whole-panel surge protector is the cheapest insurance an electrician can sell you. It clamps voltage spikes — utility switching, downed lines, summer storms — before they reach your TVs, HVAC boards, and laptop chargers. Installed in roughly an hour.

Most homes are over-lit at the ceiling and under-lit at the counter. We plan circuits, layer ambient/task/accent, spec fixtures (or work with yours), and dim properly so a 6 PM dinner doesn't feel like a dentist office.

Frederick has a lot of houses older than the National Electric Code. We open walls only where we need to, abandon legacy circuits cleanly, and rewire one room at a time so you're not living in a job site for six weeks.

Hot tubs need a dedicated 240V circuit, a GFCI disconnect within line-of-sight, and a bonding grid. We do all of it. We also coordinate trenching and conduit so your patio doesn't get torn up twice.

Bonus rooms, sunroom additions, and basement offices are usually under-served by the central system. Electric radiant or hydronic baseboard, paired with a smart thermostat per zone, is often cheaper than rerouting ductwork.

Diagnostic work, troubleshooting, replacements, and the small jobs nobody else returns calls on. If you have a list on the fridge, we'll work through it in a single visit.